35CrMo钢表面铁基激光熔覆层的组织和耐磨性能

采用CO2激光熔覆装置将LC3530铁基粉熔覆在35CrMo钢基体表面,研究了熔覆层的显微组织、硬度和耐磨性能,并与基体的进行对比。结果表明:基体组织为回火索氏体,晶粒尺寸在20μm左右,而熔覆层的组织为均匀细小的等轴晶,晶粒尺寸大多在8μm;基体的平均硬度为254.1HV,而熔覆层的平均硬度为640.5HV,且硬度分布更加均匀;在相同试验条件下,熔覆层试样的磨损量仅为基体试样的1/7,磨损系数是基体试样的1/5,且磨损后熔覆层试样的表面粗糙度较磨损前的大幅下降,表明激光熔覆后35CrMo钢的耐磨性能得到显著提高;基体试样的磨损机制为犁削磨损,而熔覆层试样的磨损机制为微观切削,其优异的耐磨性能与含有铁、铬、钼和碳等元素的高硬度合金碳化物的形成有关。     

和成矿业洗矿系统改造实践

针对和成矿业井下原矿含泥量和含水量较大，且矿泥中存在绿泥石、高岭土等黏土类矿物，造成供矿系统粘堵严重，系统台时量仅为设计水平一半的问题，对原矿进行了洗矿工艺研究。通过洗矿工艺，将原矿中的矿块和矿泥分离，实现矿块和矿泥按粒度分选，彻底解决了供矿系统粘堵严重的问题，稳定了磨选系统给矿量。     

Research on heat dissipation performance and flow characteristics of air‐cooled battery pack

With the depletion of fossil fuels and the aggravation of environmental pollution, the research and development speed of electric vehicles has been accelerating, and the thermal management of battery pack has become increasingly important. This paper selects the electric vehicle battery pack with natural air cooling as the study subject, conducts simulation analysis of the heat dissipation performance of battery packs with and without vents. Then this paper researches on the influence of internal flow field and external flow field. Field synergy principle is used to analyze the effect of velocity field and temperature field amplitude. The results show the following: it is found that the maximum temperature rise and the internal maximum temperature difference of the battery pack with vents are reduced by about 23.1% and 19.9%, raising speed value can improve the heat dissipation performance, and raising temperature value can decrease the heat dissipation performance. Reasonable design of the vents can make the inner and outer flow field work synergistically to achieve the best cooling effect. Then the reference basis for the air cooling heat dissipation performance analysis of electric vehicle, battery pack structure arrangement, and air‐inlet and air‐outlet pattern choosing are offered.     

Data envelopment analysis based on team reasoning

Existing approaches to data envelopment analysis focus mainly on the derivation of the efficiency of the individual decision‐making unit (DMU) or on the calculation of the weights of multiple inputs or outputs, but pay little attention to the team interest of all the DMUs. Motivated by the idea of team reasoning, in which the benefit of the team is of higher importance than that of each individual, this paper considers all the DMUs as a team and introduces the team indexes including the overall efficiencies, variance, boundaries of all the DMUs, and relationships between DMUs. Several models are first developed to estimate values of the team indexes based on which decision makers can provide their preferences regarding them. Then, models are established to obtain the interval efficiencies of individual DMUs under the condition that the team indexes are satisfied. Several examples are given to illustrate the proposed approaches and verify their applicability.     

A first-principles investigation on mechanical and metallic properties of titanium carbides under pressure

The titanium carbides are potential candidates to achieve both high hardness and refractory property. We carried out a structural search for titanium carbides at three pressures of 0 GPa, 30 GPa and 50 GPa. A phase diagram of the Ti-C system at 0 K was obtained by elucidating formation enthalpies as a function of compositions, and their mechanical and metallic properties of titanium carbides were investigated systematically. We also discussed the relation of titanium concentration to the both mechanical and metallic properties of titanium carbides. It has been found that the average valence electron density and tractility improved at higher concentrations of titanium, while the degree of covalent bonding directionality decreased. To this effect, the hardness of titanium carbide decreases as the content of titanium increases. Our results indicated that the titanium content significantly affected the metallic properties of the Ti-C system.     

转向系参数对汽车拖车组合系统稳定性的影响

车身摆振是汽车拖车组合系统中一种复杂的动力学失稳现象，它常常表现为车身折叠、侧滑、侧倾等行为，给道路交通安全带来了巨大的隐患。针对此问题，应用拉格朗日方程建立了考虑牵引车转向系统的汽车拖车组合系统6自由度非线性综合模型，并通过非线性分析方法研究了转向系惯性参数和各个结构刚度、阻尼对汽车拖车组合系统稳定性的影响。结果表明，转向系结构参数对系统稳定性存在不同影响，合理选择转向系结构参数可以有效提高汽车拖车组合系统的动态稳定性。     

On cutting temperatures in high and ultrahigh-speed machining

Since Dr. Carl Salomon proposed the well-known hypothesis on cutting temperatures in 1931, the debate on the hypothesis has never stopped. It shows that ev     

水平衡法与高温转化法在矿泉水氢氧稳定同位素测定中的应用

为了鉴别不同品牌矿泉水标注水源地信息真伪,对11种不同品牌饮用水的氢氧稳定同位素(δD和δ18 O)进行测定。结果表明,水平衡法(GasBench-IRMS)和高温转化法(TC/EA-IRMS)的测定结果一致性较好,两种方法测定6种不同饮用水的δD和δ18 O的平均差异分别为(0.6±1.59)‰和(0.02±0.13)‰。水平衡法需要较长的制备和测定时间,但δD和δ18 O的测定精度明显优于高温转化法。11种饮用水δD和δ18 O变化范围较大,其δD和δ18 O受不同品牌饮用水的水源地降水影响形成明显的地域性。虽然无法区分矿泉水是否由其他类别饮用水伪造,但δD和δ18 O可以为特定区域(如高海拔与沿海地区)以及产地相近的矿泉水水源地鉴别提供依据。